Promas Edge Bander for shaped work pieces - new sold

Description

Edge Bander for shaped pieces
make Promas
type PM 14 S

work piece width min. approx. 30 mm
work piece thickness 8 – 50 mm
work piece length min. approx. 200 mm
edge thickness 0,4 – 3,0 mm
inner radius 25 mm (special design optional)
heating power glue container 2,7 kW
working height approx. 875 mm
electrics connection 230V, 50 cycles , 1 phase
total connected load 3,0 kW
pneumatics 6 barrequired space approx. 1000 x 700 x 875 mm without foil disk
weight net approx. 260 kg

Direct glue application onto the edge material:
glue container leak proof with glue storage from bottom and short heat-up time after machine stop
automatic start of application roller after approx. 4-5 min.
pressure roller driven by gear motor, infinitely variable via potentiometer 0-15 m/min.
automatic edge infeed and automatic trimming process at straight work pieces via limit switch, when having shaped work pieces via foot switch
pneumatic roll separating device max. 3 x 30 mm

Additional equipment (optional):
- chassis (4 guidable rolls)
- top pressure station
- automatic work piece pressure for templates
- pressure roll set (4 pcs.) for softforming
- hot air blower 3000 W, with electronic temperature control and hot air nozzle for heating of thick edge material from the outer side
(for better shaping of thick edges when having irregular shaped work pieces)
- digital edge trimming device (automatic trimming of the defined edge length)
- work piece support rail, approx. 400 mm (extendable)