Homag CNC-Processing Center with Edge Banding - second-hand not available

Descripción

CNC processing center with edge banding
Make HOMAG
Type GENIUS BAZ20/50/14/V/K

Workpiece length max. 5,600 mm with single occupancy,
max. 2,200 mm with pendulum configuration

workpiece width max. 1.400 mm

workpiece thickness with edge max. 40 mm, without edge max. 60 mm
with standard clamp, without edge max. 120 mm
with clamping templates (provided by customer)
for chamfer milling min. 12 mm
for radius milling min. 2 x radius+ 10 mm

max. travel speeds:
in X and Y direction 80 m/min
additional Y-axis for short changing times
in Z direction 30 m/min

Console clamping table
Clamping consoles with hose-free vacuum guide 9 pcs
with integrated lifting device 8 pcs
Longitudinal stops 10 retractable, stroke 140 mm
Side stops 3 retractable left and right
Working height lower edge of workpiece 920 mm.

Lifting rail 4 pcs.
with integrated transport rollers, mounted on the side of the console.
Lifting device, free space under the workpiece support 100 mm
Total stroke approx. 105 mm.
Lifting capacity per lift rail 35 kg.

Chip conveyor belt, conveying direction: to the right

Milling spindle 12 KW/ S1
Tool holder HSK F63
water-cooled
Swivel drive C-axis with torque transmission and 3-point support
Swivel range without limitation
hose-free compressed air supply.
Tool weight max. 6 kg including holder.
Tool length max. 200 mm from motor spindle bottom edge
Tool diameter max. 180 mm for milling tools, max. 200 mm for grinding tools
Speed range infinitely programmable 1,500 - 18,000 rpm.
Full nominal power from 12.000 rpm
Plate changer 12-fold

The following tool and unit configurations are possible:
12 x diameter max. 130 mm
or
6 x diameter max. 180 mm and 6 x diameter max. 70 mm

Tool diameter max. 200 mm for grinding tools

drilling head 9 spindles vertical
individually retrievable
spindle distance 32 mm
in X direction 5 spindles
in Y direction 5 spindles
Engine, 1.5 kW,
50 Hz, 7,500 rpm.
Extension stroke 50 mm.
Bore diameter max. 35 mm

GLUING PART 360 DEGREES /V/
for 360 degree gluing with joint,
For edges with DIRECT glue indication.
Edge height max. 45 mm
edge thickness plastic 0.4 - 3 mm
Veneer 0.4 - 2 mm
edge length min. 230 mm

6-fold automatic edge change
1 pre-crosscut station
Single edge feed

Operating voltage 380/400 Volt, 50/60 Hz.
Control voltage 24 Volt

HOMATIC CONTROL: NC83
with SPS control
Programming WoodWop

The plant is still in operation at the moment and will be vacated in September 2020.

Subject to prior sale